|Other Name:||Bitumen Road Repair||Softening Point:||96℃，93℃，91℃，87℃，81℃|
|Main Raw Material:||Asphalt||Heating Temperature:||160℃~170℃|
|Package:||Hot Melt Film And Carton||Asphalt Compatibility:||Compatible|
|Type:||Pavement Crack Sealant||Application:||Asphalt Pavement|
96 deg Softening point Asphalt Road Maintenance,
93 deg Asphalt Road Maintenance,
Compatible crack sealing asphalt roads
ZTA bituminous sealant is a high-performance modified asphalt product. It has strong cohesiveness, can form firm adhesion to cracks, and is not easy to fall off, effectively preventing moisture from entering the interior of the road surface and causing damage to the road surface.
ZTA road crack sealant has good viscoelasticity and can change with the change of the crack width caused by thermal expansion and contraction of the road surface. The effect is better, and it can be used for 3-5 years, stored for more than 2 years.
To repair the cracks in asphalt pavements perfectly, the key is to choose a suitable type of sealant. Choosing the appropriate sealant as the material for pavement crack repair according to different regions & different climatic conditions and pavement crack characteristics. The product is divided into high temperature type, common type, low temperature type, cold type and severe cold type.
|Type||Penetration/0.1mm||Softening point/℃||Flow value(mm)||Elastic recovery ratio/%||Low temperature stretching|
|Test temperature/℃||Maximum displacement/mm||conclusion|
|High temperature type||51||96||0||70||0||9.005||pass|
|Low temperature type||89||90.50||2.01||55||-20||45.600||pass|
Stable performance of high and low temperature. Does not flow at high temperatures and does not crack at low temperatures.
Extremely high performance of water resistance and aging resistance. Good stable performance & not easy to segregate & Impervious to oil.
It has strong adhesion and high elasticity. It can be closely combined with the interface, and it is not easy to fall off in the absence of water.
Ease of use. Reasonable viscosity, good fluidity, no impurities, and no block equipment.
Good construction and workability, no impurities do not block damage to the machine.
Long service life and less maintenance. The service life can reach 3-5 years, which is 2-3 times the service life of other materials.
1. Before filling, ensure that the cracks are dry and there is no water or rain within 24 hours before and after potting.
2. Whether to slot the joints according to customer requirements. Dust must be purged before potting.
3. When the temperature during the construction of the joint is lower than 5 °C, the crack should be preheated by a hot spray gun.
4. The filling joint is constructed by a filling machine with a stirring function. The sealing glue should be continuously stirred during the construction process. The sealing glue needs to be heated to 180-190 °C before the filling can be applied.
5. After the construction of the joint, it should be allowed to stand for 20 minutes to open the traffic. If it is open traffic immediately, it needs to sprinkle a small amount of fine sand or talcum powder, cement and other spacers to prevent the glue from sticking to the tire.
6. After the filling construction is completed, the sealing machine should be cleaned and the sealant should be avoided in the filling machine. After each section of the jointing construction, the filling machine should be cleaned.
Contact Person: Shakiya